1. WRIST BAND : Conductive Strap sew onto the Velcro Band
2. COILDED CORD : PU(Polyurethene) cable. Straight cord 8ft
3. OUTER DIAMETER : 2.5 +/-0.1 MM
4. RESISTOR :  1 Meg Ohm ¼ watt (Crimped and soldered on top of the socket) +/-2%
5. INSULATION : Polyurethene
6. BANANA PLUG/SNAP BASE HOUSING : Moulded with strain relief and cord restrain
7. FEMALE SNAP : 4mm

TESTING

1. PULL FORCE TEST
   Use the push-pull gauge pull the button from wrist strap. Pull force require to remove shown on the gauge as below :
   
   

   Test No.	Force
   1	1.9 kg
   2	2.0kg
   3	2.1kg
   4	1.5kg
   5	1.5kg

   
   Required Spec : 1lb -  5lb (0.45 – 2.25kg)
   
   
2. CONDUCTIVITY TEST
   Connect the both ends of the cable to the multimeter. Reading shown as below :
   
   

   Test No.	Resistance(M Ohm)
   1	0.983
   2	0.999
   3	1.003
   4	1.000
   5	0.995

   
   Required Spec : 1 M Ohm
   
   
3. STRETCH TEST
   a. Speed  30 times per minute
   b. 10 000 times stretching
   c. Stretch length : 5 times longer than test piece
   
   

   Test No.	Close coil length		% Ratio Change
   	Before	After
   1	280mm	280mm	0
   2	270mm	272mm	0.3
   3	275mm	277mm	0.3
   4	277mm	280mm	0

   
   
4. BUTTON ROTATE TEST
   a. Button rotate 360 deg on wrist strap
   b. Direction clock wise anti-clock wise
   
   

   Test No.	Rotate arc 360 deg
   1	Pass
   2	Pass
   3	Pass
   4	Pass
   5	Pass